Exinda SD-WAN Management Interface
Accessing the Exinda SD-WAN Management Interface
The Exinda SD-WANSoftware-Defined Wide Area Network takes approximately 60 seconds to initialize after powering up. After that, you can access the Exinda SD-WANWide Area Network Management Interface. Connect an Ethernet cable from a PC to any of the Exinda SD-WAN’s LANLocal area network ports and go to http://192.168.254.99/ in a browser.
The Exinda SD-WAN Management Interface is accessible on any computer with a web browser on the local network. With the local network configured, it is not necessary to plug the computer directly into the Exinda SD-WAN in order to access the Exinda SD-WAN Management Interface.
If the Exinda SD-WAN Management Interface cannot be accessed, make sure the management computer is configured to accept a “dynamic IPInternet protocol” address from a DHCPDynamic Host Configuration Protocol server which is in this case, the DHCP server of the Exinda SD-WAN. By default, the DHCP server of the Exinda SD-WAN is enabled, but it can be disabled through the Exinda SD-WAN Management Interface. In order to access the Exinda SD-WAN Management Interface when the DHCP server is disabled and no other active DHCP is accessible, a static IP address should be assigned to the management computer. It is recommended to use the static IP address 192.168.254.10 for the management computer in this case.
The Exinda SD-WAN Management Interface presents up the following tabs to access its functionality: Home, Advanced, VLL, Firewall, Status, and Admin.